Features:
- Easy to Apply
- Abrasion resistant
- High bond strength
- Solvent free
- Suitable for Multi-Storey CarParks
- Suitable for Concrete Roof Decks
- Suitable for Factories/Warehouses
FeRFA Resin Flooring guidelines
Description:
Applied in two or more coats. Generally solvent or water borne.
Duty:
light foot traffic, occasional rubber tyred vehicles.
Typical Thickness:
up to 150 µm
Description:
Applied in two or more coats. Generally solvent free.
Duty:
light foot traffic, occasional rubber tyred vehicles/regular foot traffic, frequent fork lift truck traffic, occasional hard plastic-wheeled trolleys
Typical Thickness:
150 µm to 300 µm
Description:
Applied in two or more coats. Generally solvent or water borne.
Duty:
lregular foot traffic, frequent fork lift truck traffic, occasional hard plastic-wheeled trolleys
Typical Thickness:
300 µm to 1000 µm
Description:
Aggregate dressed systems based on multiple layers of floor coatings or flow-applied floorings, often described as ‘sandwich’ systems.
MD/HD
Duty:
regular foot traffic, frequent fork lift truck traffic, occasional hard plastic-wheeled trolleys/constant fork lift truck traffic, hard plastic wheeled trolleys, some impact
Typical Thickness:
> 2 mm
Description:
Often referred to as ‘self-smoothing’ or ‘self-levelling’ flooring and having a smooth surface.
Duty:
regular foot traffic, frequent fork lift truck traffic, occasional hard plastic-wheeled trolleys/constant fork lift truck traffic, hard plastic wheeled trolleys, some impact
Typical Thickness:
2 mm to 3 mm
Description:
Trowel-finished, heavily filled systems, generally incorporating a surface seal coat to minimize porosity.
Duty:
regular foot traffic, frequent fork lift truck traffic, occasional hard plastic-wheeled trolleys/constant fork lift truck traffic, hard plastic wheeled trolleys, some impact
Typical Thickness:
> 4 mm
Description:
Having a smooth surface.
Duty:
constant fork lift truck traffic, hard plastic wheeled trolleys, some impact/severe heavily loaded traffic and impact
Typical Thickness:
4 mm to 6 mm
Description:
Trowel-finished, aggregate filled systems effectively impervious throughout their thickness.
Duty:
severe heavily loaded traffic and impact
Typical Thickness:
> 6 mm
Standard colours are White and Safety Yellow, other colours can be achieved, please contact the Technical department with your request.
All materials are provided in preproportioned units. Mixing of part units is not recommended due to the possibility of proportioning errors. Mixing of the hardener component is recommended before mixing the two liquid components. Mix both liquid components together for a minimum of two minutes or until a homogeneous mix is obtained.
0.040Kg/Ln/m (Based on 100mm Wide). Approx 300 microns D.F.T. (Dry Film Thickness) Dependant on Surface texture and or porosity. Sometimes a 2nd coat may be required.
Physical Characteristics@20°c cure schedule:
Pot life @ 20°C -30-45 minutes
Touch dry@ 20°C -6-8 hours
Overcoat period -8-24 hours Full cure -7 days
Please read the relevant technical data sheet and specific health and safety data for this product provided in compliance with the requirements of EC Directive 91/155.
To be assured of maximum adhesion and properties from Page resin products, the correct surface preparation is essential. Please refer to the technical department.
10°C – 30°C. Ideally 20°C. Protect from adverse weather conditions during early cure stages. Apply using a medium pile roller. Please note in warmer climates speed of application is paramount due to reduced open times.
The storage, mixing and application conditions can affect the quality of the finish produced.
